Micro Die Adjusters

Adjusting a 7/8-14 threaded sizing die (or threaded seater die) to the exact shoulder bump you need is a laborious process. This set of seven 7/8” die shims enables you to set the die up once, then adjust the die in small, exact increments without...

Imperial is the original finger applied “wax” type case sizing lube which many shooters have preferred for decades. Imperial is an extremely hi-lubricity lubricant which is recommended for case sizing, necking up cases, or many case-forming...

"Sure, it's straight, but can you make it straighter?"- That simple statement started us on the path to make perfection even better. Not all reloading presses are created equal. In fact, a lot of them are about as crooked as the politicians you see...

 For as long as we've been reloading we've always hated setting up our full length sizing dies. We've been using shims to help this along for quite a long while now, but have not really been pleased with them. It seems we always misplace them, or...

For as long as we've been reloading we've always hated setting up our full length sizing dies. We've been using shims to help this along for quite a long while now, but have not really been pleased with them. It seems we always misplace them, or can't...

The same problems in adjusting 7/8-14 sizing dies can be found on larger dies for sizing "big boy" cartridges that require 1 1/4"-12 dies. The PMA Micro Die Adjuster addresses these problems and replaces the lock ring on sizing dies with a...

The same problems in adjusting 7/8-14 sizing dies can be found on larger dies for sizing "big boy" cartridges that require 1 1/2"-12 dies. The PMA Micro Die Adjuster addresses these problems and replaces the lock ring on sizing dies with a...

New look, same formula! Royal Case & Die Lube from Sharp Shoot R products is an extremely high lubricity case sizing lubricant which leaves no tacky residue and wipes off very easily. Will not gum up, safe enough to eat, protects dies and cases from...

Set of ten, stainless steel .003” - .020” shims for Wilson Hand Seater Dies (shims slip onto seater stem). Set up your bullet seating die with a middle thickness shim and increase or decrease seating depth without needing to change the...

Set of ten stainless steel .003” - .020” shims for Wilson Hand Seater Dies (shims slip onto seater stem). Set up your bullet seating die with a middle thickness shim and increase or decrease seating depth without needing to change the initial...